Search:

Type: Posts; User: Allan E.

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    1
    Views
    2,208

    Sticky: Postings, Viewings, and Permissions

    Anyone having trouble posting, if you're new, you will need to be patient. If you have not been cleared for posting, the admin hasn't gotten to you yet.
    If you can post text, but not pictures, your...
  2. Replies
    1
    Views
    1,140

    The 74/75 IH axle will bolt up. 73-87 Chevy axle...

    The 74/75 IH axle will bolt up.
    73-87 Chevy axle will bolt up, almost exact, but minor differences, and the steering is different.
    Dodge, about the same from the early 70s through the mid 80s....
  3. Replies
    1
    Views
    1,834

    The bell housings do not match. It is likely that...

    The bell housings do not match. It is likely that you could find the right bell housing, though.
    The flywheel on the SV series is weighted to balance the engine, so the flywheel would not work on...
  4. The carb for that engine is a Holley 1904. They...

    The carb for that engine is a Holley 1904. They came in two sizes, apparently. The big one works.
  5. Replies
    1
    Views
    1,797

    The IH engines are the only ones with that bell...

    The IH engines are the only ones with that bell housing. They aren't too hard to find in the lower 48, but in Alaska, they're not as common. You could change the bell housing and use an IH V8 also....
  6. Replies
    2
    Views
    2,054

    I suggest you re-think this. If you need to...

    I suggest you re-think this. If you need to stabilize the steering, you should figure out why before you start making modifications. There's a guy in Bremerton that makes a straight steer brace that...
  7. You might want to check into a Stax or Atlas...

    You might want to check into a Stax or Atlas transfer case. There may be a different t-case that will give you a right hand drop.

    Another option is a bronco front axle. Don't know if the spring...
  8. Thread: 1975 scout ii

    by Allan E.
    Replies
    2
    Views
    2,523

    Good deal! Let me know if you change your mind...

    Good deal!

    Let me know if you change your mind again. I can give it a good home across the mountain in Prosser.
  9. Replies
    1
    Views
    1,623

    Yes. It's a little too long so that it will work...

    Yes. It's a little too long so that it will work with body lifts, etc.
  10. Replies
    3
    Views
    1,793

    Fuel economy is affected by getting the air fuel...

    Fuel economy is affected by getting the air fuel mixture correct throughout the rpm range, having the timing set correctly throughout the rpm range, and having a transmission that doesn't slip. An...
  11. Replies
    2
    Views
    2,064

    The Gremlin might be the same, since the engine...

    The Gremlin might be the same, since the engine vintage is the same. Either way, it should bolt up. I'd take the pump and brackets and give them a try.
  12. Replies
    1
    Views
    956

    Leaf spring bushings are available in pretty much...

    Leaf spring bushings are available in pretty much any size. You just need spring width, eye width, and center bolt size.
  13. Replies
    3
    Views
    1,900

    The I terminal is just for cranking. The standard...

    The I terminal is just for cranking. The standard hookup takes the R terminal on the starter to the coil. The "reasons" to do this modification are many: 1. You can put the main wiring...
  14. Find Triple Diamond Four Wheelers. They are in...

    Find Triple Diamond Four Wheelers. They are in your area. They also have a facebook page. One of the guys has 304/345/392 engines, some ready to drop in that would work for you.
  15. Replies
    1
    Views
    1,257

    Outback Parts in Spokane, Back Country 4x4 in...

    Outback Parts in Spokane, Back Country 4x4 in Bremerton, Superscoutspecialists (dot com) in Springfield, Ohio, and yes, they can be custom made by cable shops. Farm supply places or anywhere that...
  16. Replies
    9
    Views
    41,969

    Unless you spun a bearing, it is very unusual to...

    Unless you spun a bearing, it is very unusual to need to turn a crank in one of these engines. I have torn down several of them and have yet to see one that needed to be turned. (345 uses same crank...
  17. Replies
    3
    Views
    1,028

    I know of at least one IH nut with a whole lot of...

    I know of at least one IH nut with a whole lot of knowledge in Helena, MT. Look around.
  18. Replies
    13
    Views
    2,349

    If you can make it home, don't use the Bars. It...

    If you can make it home, don't use the Bars. It is insane to plug up perfectly good capillaries in a new cooling system instead of fixing the problem. If it isn't spraying water, just drive it home....
  19. IH Only is in Lancaster, CA. It helps to know...

    IH Only is in Lancaster, CA. It helps to know what town you are in if you want help, because Southern California is a pretty big place. Look up Scouts West and find a member near you. (begin new...
  20. Replies
    4
    Views
    1,137

    You need to use the gasket, yes. You have the...

    You need to use the gasket, yes. You have the symptoms of somebody who used black RTV instead of a gasket.
  21. Replies
    4
    Views
    1,137

    If the leaky engine has good compression, seal up...

    If the leaky engine has good compression, seal up the gaskets and use the carb from the one with the blown gasket/cracked head/whatever. Most likely that was the original problem. You'll need to...
  22. Replies
    13
    Views
    2,349

    If it's just weeping, probably. Watch your temp...

    If it's just weeping, probably. Watch your temp gauge. If it just leaks a little, you're okay. If you start spraying all over the place, maybe not. it isn't hard to change a water pump on that...
  23. Replies
    3
    Views
    1,028

    Sometimes they get wallowed. A torch is often a...

    Sometimes they get wallowed. A torch is often a method. You have to decide what's hold it it up and how to overcome it.
  24. Replies
    1
    Views
    1,182

    When you are in the START position, the coil...

    When you are in the START position, the coil voltage goes away. It is supplied from the R terminal on the starter solenoid, giving a full 12 volts instead of the normal 6 volts you get in the RUN...
  25. Replies
    2
    Views
    765

    The capacity is 6 quarts, but more than 7 will...

    The capacity is 6 quarts, but more than 7 will cause problems from overfilling. The dipstick is in the front. The pickups do have a different oil pan. The loadstar oil pan is 10 quart capacity. It...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4