Results 1 to 6 of 6

Thread: stall..

  1. #1
    Join Date
    May 2009
    Location
    baltimore
    Posts
    4

    Default stall..

    ok, so I'm new to this. I just purchased a 75 scout II. Had minor work done - carb, starter & distributor. Then it drove fine. It sat for about 2 weeks, now it stalls whenever I put it in drive. Starts fine, just idles too low and stalls.

    suggestions?

  2. #2
    Join Date
    Mar 2009
    Location
    Las Vegas
    Posts
    208

    Default

    Turn up your idle screw some, and what motor does this have?
    '71 Basterd Scout 2
    with a 258 from a '73 CJ5
    Intake manifold with NHRA markings....go figure

    "Its (scout) four-wheel-drive capabilities are equal to anything this side of full tracks"

    David H. Petraeus for President 2012

  3. #3
    Join Date
    May 2009
    Location
    baltimore
    Posts
    4

    Default

    thanks. thats what I though...but again, i'm new to this.
    it is a '75, 8cyl. 304 (or 302?)

    i'm trying to fond a diagram/pic of where this screw actually is. any advice?

    thanks for the help!

  4. #4
    Join Date
    Mar 2009
    Location
    texas
    Posts
    24

    Default

    Depending on model, may be at back of carb near the base where it bolts into the intake.

  5. #5
    Join Date
    May 2009
    Location
    baltimore
    Posts
    4

    Default

    thanks. Another relatively dumb question. how do i determine the model?

  6. #6
    Join Date
    Mar 2009
    Location
    Las Vegas
    Posts
    208

    Default

    Is the carb a 4 barrel aftermarket or is it a stock 2 barrel?
    '71 Basterd Scout 2
    with a 258 from a '73 CJ5
    Intake manifold with NHRA markings....go figure

    "Its (scout) four-wheel-drive capabilities are equal to anything this side of full tracks"

    David H. Petraeus for President 2012

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •