Results 1 to 3 of 3

Thread: Ball join removal

  1. #1
    Join Date
    Apr 2009
    Location
    San Luis Obispo, California
    Posts
    283

    Default Ball join removal

    What is the easiest way to remove your ball joints?



    And has anyone used these / installed these? Any thoughts?

    https://www.superscoutspecialists.co...-scout-ii.aspx

    -Thanks guys
    -72 Scout2 - SBC350 with RV camshaft, 4 speed manual Trans, D20 xfer case with CV drive shafts.
    -Dana 44 Detroit locker rear.
    -Dana 44 (out of a 75) Rebuilt /w trutrac limited slip frnt



    ~Conquest is not in our principles. It is inconsistent with our government.

    ~T.J.

  2. #2
    Join Date
    Feb 2009
    Location
    Interior Alaska
    Posts
    227

    Default

    For the ball joints themselves, use a large C-Clamp like press (similar to harbor freights part number 38335-9VGA) but get a good one, Napa / Shucks / Carquest may have a loaner tool for you to use. I have used this tool for spring bushings, u-joints, ball joints, caliper bolt removal & as a smaller press for some jobs.

    I cannot comment to the link you have posted, looks interesting though.

    HTH

    Bill

  3. #3
    Join Date
    Apr 2009
    Location
    San Luis Obispo, California
    Posts
    283

    Default

    Thanks man, ill go check the parts stores in the morning
    -72 Scout2 - SBC350 with RV camshaft, 4 speed manual Trans, D20 xfer case with CV drive shafts.
    -Dana 44 Detroit locker rear.
    -Dana 44 (out of a 75) Rebuilt /w trutrac limited slip frnt



    ~Conquest is not in our principles. It is inconsistent with our government.

    ~T.J.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •